Keysight 53210A Mode D'emploi page 31

Applying Power
Connect the power cord and press the "on/standby" button on the front panel
(
self-test which includes:
– power supply verification
– FPGA test
– front panel verification
– measurement board verification
– channel 2 test (if present)
– Option 300 battery test (300 if present)
If the 53210A does not turn on when the on/standby button is pressed, verify AC
NOTE
power is available to the instrument and that the power cord is securely
connected. If the instrument still does not turn on, the cooling fan is not audible,
or if the front panel display is off when power is applied, return the unit to
Keysight for repair.
Power-On LED Status
The led located under the on/standby button is an indication of the on/off/
standby condition of the instrument. The different conditions are summarized in
the table below. The 'off' status is determined by the presence of OXCO Option
010.
Keysight 53210A User's Guide
). During the power-on sequence the counter performs an auto-calibration and
Preparation for Use 1
31