Keysight 53210A Mode D'emploi page 166

6 53210A Math, Graphing, and Data Logging
Viewing Histograms
At power-on or when the front panel Preset key is pressed, numeric data is
displayed. Remotely, histograms can be displayed by changing the display mode
using the command:
DISPlay[:WINDow]:MODE {NUMeric|HISTogram|TCHart}
DISPlay[:WINDow]:MODE?
The Graph key followed by the Histogram softkey enables and automatically
starts histograms from the front panel. Histograms can also be turned off from the
softkey menu.
Remotely, a reset (
the display mode.
Histograms correspond to readings in reading memory - starting at the time the
histogram is enabled and ending when the product of the trigger count
(
TRIGger:COUNt
continuous (i.e. internal), the histogram continually updates from the point it was
enabled.
Figure 6-6
166
) or instrument preset (
*RST
) and sample count (
describes the information provided in a typical histogram window.
SYSTem:PRESet
) is reached. If triggering is
SAMPle:COUNt
Keysight 53210A User's Guide
(query form)
) does not change