Keysight 53210A Mode D'emploi page 174

6 53210A Math, Graphing, and Data Logging
Resetting the Histogram
The data from which the current histogram is created is cleared by any of the
following:
– pressing the Reset Histogram softkey
– enabling/disabling or changing any part of the histogram
– a new measurement cycle
– sending a new SCPI command or changing a current SCPI parameter
– an instrument reset or present
These actions also clear all readings in reading memory and in the output buffer.
To clear histogram data without clearing the readings in reading memory, the
following command is used:
CALCulate2:TARNsform:HISTogram:CLEar[:IMMediate]
174
– number of bins, lower or upper range
- INITiate:IMMediate
,
- *RST SYSTem:PRESet
, ,
READ? MEASure
Keysight 53210A User's Guide