Keysight 53210A Mode D'emploi page 208

7 Formats and Data Flow
<file>
is "[
(external memory device).
specified, it must have been previously created (see
The combination of folder and file name cannot exceed 240 characters, and
cannot contain the characters \ / : * ? " < > |. State files have a .sta extension.
State File Example
The following example shows the interaction between folders created from the
front panel and state files created/stored programmatically. For this sequence,
folder
then specified (programmatically) as the current folder and a state file is stored
and recalled from that folder.
MMEM:CDIR "INT:\SETUP_1"
configure instrument programmatically or from front panel
MMEM:STOR:STAT "test1.sta"
recall the configuration (state) at later date (even if power is
cycled)...
MMEM:LOAD:STAT "INT:\SETUP_1\test1.sta"
Saving States from the Front Panel
With the instrument configured as required, the state is stored from the front
panel as follows:
1 Use the Utility key and soft keys indicated on the previous page to set file
2 Press the 'Browse' soft key to display the 'File System' window. Use the front
208
is created during execution of the
drive:path]<file_name>
was created on the internal flash drive from the front panel. It is
SETUP_1
action 'Store'.
panel knob to highlight the root directory or a folder in the counter's internal
flash memory (Internal) or on the USB drive (External). If folders are not visible,
press 'Browse' again to view the directory structure.
STORe
". is either
drive INT
is an absolute path and folder name. If a folder is
path
// specify as current folder
// store the configuration
command. The parameter format
(internal flash memory) or
MMEMory:MDIRectory
// load state
Keysight 53210A User's Guide
USB
).