Keysight 53210A Mode D'emploi page 130

5 Triggering and Gating
– trigger source
– trigger source
– trigger source
Trigger Source Example
//configure for frequency, set system trigger parameters
CONF:FREQ 5E6,0.1,(@2)
System Trigger Slope
When the system trigger source is set to
the signal is set with the command:
TRIGger:SLOPe {POSitive|NEGative}
TRIGger:SLOPe?
- trigger slope
NEGative
'Trig In' BNC. By default,
130
IMMediate
sets the trigger source to
CONFigure
EXTernal
to the rear panel '
Trig In
causes the instrument to be triggered by the
BUS
received over an IO interface.
TRIG:SOUR EXT
POSitive
selects the signal's falling edge. The signal is applied to the
sets a continuous trigger signal. By default,
IMMEDiate.
sets the trigger source to an external trigger applied
' BNC connector.
// trigger source external
EXTernal
selects the signal's rising edge, and trigger slope
sets the trigger slope to
CONFigure
*TRG
, the triggering slope (edge) of
(query form)
NEGative.
Keysight 53210A User's Guide
command