Keysight 53210A Mode D'emploi page 58

2 53210A Software Installation and Interface Configuration
Installing Instrument Drivers
Interchangeable Virtual Instrument (IVI) drivers (when available) are used for
programming the 53210A with Keysight VEE, with National Instruments®
LabVIEW™, or in Microsoft® development environments.
Install the appropriate driver based on the development environment you are
using
prompted. Setup type "Typical" is applicable for most users.
Installing the Keysight IO Libraries installs the Interchangeable Virtual
NOTE
Instrument (IVI) Shared Components. The IVI Shared Components are required
before the IVI drivers (e.g. IVI-COM, IVI-C)can be installed.
Adding Instruments to the PC Interface
During installation of the Keysight IO Libraries, the IO interfaces (LAN, USB, GPIB)
detected on the PC are configured. This section contains information for
programmatically adding the 53210A to those interfaces using the Keysight IO
Libraries 'Connection Expert' utility.
Simultaneous LAN/USB/GPIB connections to the instrument are allowed.
The figures used in this chapter represent the latest version of the IO Libraries
NOTE
available at the time of printing. While you may have a different version, the
process of configuring and adding instruments remains basically the same.
58
(Table 2-1). Accept all default d irectories specified d uring installation if
Keysight 53210A User's Guide