Bosch GVCI-MX Mode D'emploi page 8

en en 8 | GVCI-MX | Product Description GVCI-MX
4.4 GVCI-MX connectors and controls
A number of standard connectors and controls are avail-
able on the GVCI-MX to facilitate operation and com-
munication with vehicles and workshop networks. These
connectors and controls are shown in the following il-
lustrations.
4.4.1 Front and back side
1 2
3 4
Pos. Description
1 DB26 Connector (DLC Cable)
2 USB Port Type A (reserved for future use cases)
3 USB Port Type B (to connect to a PC / Laptop)
4 Wireless Adapter (below the boot)
5 Wireless Pairing Switch
4.4.2 GVCI-MX
1 2
Pos. Description
1 LED error indicator, vehicle and pc host communication
2 LED Indicator Power
|
1 689 989 447 2020-03-02
5
4.5 Universal Serial Bus (USB)
The GVCI-MX has a fixed USB configuration which cannot
be changed. This ensures that the GVCI-MX can always
be connected to a single PC running the VCI Manager
software so you can configure WLAN settings required
by your local network. In addition, it is important to
note that a USB connection is required to configure and
update the firmware on the GVCI-MX. USB connection
must be made directly with the PC port. Do not connect
through a USB hub.
4.6 Wireless Local Area Network (WLAN)
The 802.11g WLAN connection on the GVCI-MX is set up
and configured while the device is connected over USB
to a PC running the VCI Manager software. For setting
up a wireless connection please refer to „5.3 Setting Up
Wireless Communications".
4.7 VCI Manager software
The VCI Manager software is a host computer application
which runs on the Microsoft Windows operating system
to configure and update VCIs. The VCI Manager software
allows the configuration of VCI-to-host PC communica-
tions and facilitates VCI firmware updates.
Bosch Automotive Service Solutions GmbH