Bosch GVCI-MX Mode D'emploi page 15

3. With the GVCI-MX plugged into the PC with a USB
cable, open the device manager from the Win-
dows control panel. In device manager search for
an unknown or improperly configured device. The
GVCI-MX will likely be detected as one of the follow-
ing:
$
Other device – RNDIS Gadget with a yellow excla-
mation icon
$
Universal serial bus controllers – Unknown USB
Device
i
Right click on the device name in device manager
> Update Driver > Browse my computer for driver
software > Browse > C:\Program Files (x86)\Bosch
Software\USBDriver
4. Plug a different GVCI-MX device (VCI #2) into the PC
(PC #1). Continue if not resolved.
5. Plug the original GVCI-MX device (VCI #1) into a
different PC (PC #2) with VCI Manager software
installed on it.
6. Contact Technical Support.
If YES, then:
¶
Test if connection lost when the GVCI-MX is con-
nected to the Vehicle, then...
$
Check for Ground faults - (Battery Chargers,
Hoists...) This issue may be resolved by correct-
ing the ground fault or configuring the GVCI-MX
to connect wireless.
$
Check for an improperly wired DLC connector
i
If the VCI Manager is still not able to communicate
with the GVCI-MX, perform the Recovery Procedure
on the GVCI-MX.
Bosch Automotive Service Solutions GmbH
Cleaning and maintenance | GVCI-MX | 15
7.9 PC application is unable to communi-
cate with the GVCI-MX over wireless
Check that the wireless dongle is properly seated in the
GVCI-MX see „4.4.1 Front and back side" pos. 4.
R
Confirm the VCI can connect over USB
If using point to point confirm the PC has a single
dongle connected:
¶
Connect the GVCI-MX to the PC using USB
¶
Confirm the communication is enabled and the IP
configuration is properly set using the VCI Manager
software
If using infrastructure wireless:
¶
Contact your IT department and check that your PC
is detecting the wireless access point, and the cor-
rect security settings have been configured for the
GVCI-MX.
8. Cleaning and maintenance
8.1 Cleaning and storing
The housing of the GVCI-MX module may only be cleaned
using a soft cloth and a neutral cleaning agent. Do not use
any abrasive cleaning agent or rough cleaning cloths.
i
There are no user serviceable components inside
the GVCI-MX Vehicle Communication Interface. Do
not open the devices. Opening the devices will void
the warranty.
R
If the VCI, connectors, or cables become dirty, they
may be cleaned by wiping them with a rag lightly coat-
ed with a mild detergent or non-abrasive hand soap.
R
Do not immerse the VCI or any of its parts or accesso-
ries in water.
R
Although the VCI and accessories are water resistant,
they are not waterproof; thoroughly dry them prior to
storage.
R
Avoid using harsh solvents such as petroleum based
cleaning agents, Acetone, Benzene, Trichloroethylene,
etc.
en en
|
1 689 989 447 2020-03-02