Storing The Transfer Flat - Stryker 6005 Manuel D'utilisation

STORING THE TRANSFER FLAT

English
The Transfer Flat rolls up and forms its own carrying case. Make sure that the
transfer flat is clean and dry before storage.
To store the Transfer Flat:
1. Fold each long side over toward the center of the Transfer Flat as shown in
Figures 5 and 6.
2. Starting at either end, roll up the Transfer Flat as shown in Figure 7.
3. Slip the strap through the D-ring and snap it securely as shown in Figure 8.
The handle can be used to carry the Transfer Flat.
CAUTION
• Do not store the Transfer Flat in direct sunlight or in a moist environment.
Keep device and equipment out of direct contact with flames.
• To avoid the risk of damage, the Transfer Flat must be stored where the
temperature range is between -22 to 158 degrees Fahrenheit (-30 to 70
degrees Celsius).
Return To Table of Contents
1-14
Operation Guide
Figure 5
Figure 7
6005-009-001 REV A
Figure 6
Figure 8
www.stryker.com