Head End And Foot End Fastener Installation (Model 6385) - Stryker Power-PRO TL 6385 Manuel D'utilisation Et D'entretien

English

HEAD END AND FOOT END FASTENER INSTALLATION (MODEL 6385)

1. Remove the back cover on the foot end fastener. Mount the foot end fastener on the four floor plates and secure
with 1/2"-13 hex head cap screws and lock washers as shown in Figure 4. Secure the back cover back onto the
foot end fastener.
2. Mount the head end fastener on the three floor plates and secure with three 1/2"-13 hex head cap screws and lock
washers as shown in Figure 4.
3. Confirm fastener spacing as shown in Figure 5.
Foot End Fastener
Foot End
Foot End
Return To Table of Contents
1-12
Cot Fastener Installation
Head End Fastener
Back Cover
Figure 4: Head End and Foot End Fastener - Floor Plate Installation
Figure 5: Fastener Spacing
6385-009-005 REV B
948 MM
Head End
Head End
www.stryker.com