Electric Hook Up; Vertical Arm Spring Installation - SICE S 45 Manuel D'instructions

ENGLISH • Instructions manual
WARNING!
Use the union (2, Fig. N/2) only for the outlet of air (to
connect inflating device).
Do not connect the compressed air network to this union:
you could break the pneumatic equipment and the safety
devices.

6.6 ELECTRIC HOOK UP

Before making any electric hook up, check to be certain that the mains voltage
corresponds to what is stamped on the voltage tag (attached on the feeding
cable of the tyre changer).
It is absolutely essential that the system is equipped with a good ground-
ing circuit.
The machine must be connected to a power supply line circuit breaker set for
30mA.
Note the required power draw as highlighted on the tag-plate fixed to the back
of the tyre changer.
Check to make sure the shop electric wiring circuit is dimensioned sufficiently
to carry this.
WARNING!
Work on the electric system, even if minor, must be done
exclusively by professionally qualified personnel.
Manufacturer shall not be liable for any injury to persons
or damage to things caused by failure to comply with
these regulations and can cancel warranty coverage.

6.7 VERTICAL ARM SPRING INSTALLATION

When all installation and connection operations are complete, fit the hexagonal rod
by proceeding as follows:
1) By hand, move the hexagonal arm to the limit (fully up) position, then use the
pneumatic push-button control (9 Fig. P) to lock it in this position.
2) Use a size 6 spanner to undo the screw which fixes the knob (1, FIG.0/1).
3) Lift the knob and turn it through 180° as shown in Fig. O/2.
4) Fit the spring onto the hexagonal post.
5) Press the spring down by hand to allow the knob to be put back onto the rod.
6) Keeping the knob lightly pressed down, fix it by fully tightening the screw re-
moved earlier (see Fig.0/3).
7) Release the hexagonal arm
39
2
N/2
O/1
O/2
O/3
S 45