Tubeless Tyres; Explosion Hazard - SICE S 45 Manuel D'instructions

ENGLISH • Instructions manual
3) Make a last check to be certain that tyre and rim diameter correspond.
4) Check to be certain that rim and beads are sufficiently lubricated. If necessary
lubricate some more.
5) Press the pedal down to position 1 (Fig. U/1) to start inflation.
6) Release frequently the inflating pedal to check pressure on the manometer (1, Fig.
U/2).
Introduce more air little by little untill the correct pressure is reached.
N.B.: If you over inflate the tyre, hold the deflate button (2, Fig. U/2) until the
correct pressure is reached.
Release the button to check pressure on the manometer.

TUBELESS TYRES

N.B. When inflating tubeless tyres using a strong jet of air (BLAST MODE), the wheel
must be clamped from the inside of the rim.
1) Remove the valve stem.
2) Clip the valve onto the inflator chuck making sure it is properly connected.
3) Make a last check to be certain that tyre and rim diameter correspond.
4) Check to be certain that rim and beads are sufficiently lubricated. If necessary lubricate some more.
5) Press the pedal down to position 1 (Fig. U/1).
6) If the bead of the tyre is not well seated, due to a strong bead, lift tyre manually until the upper bead seals against the rim, then press
the pedal all the way down (position 2, Fig. U/1).
A strong jet of air will be released through the nozzles in the slides and this will help the bead seal.
7) Release the tyre; set the pedal back to position 1 (Fig. U/1) and continue to inflate the tyre to the required pressure.
N.B.: If you over inflate the tyre, hold the deflate button (2, Fig. U/2) until the correct pressure is reached. Release the button to
check pressure on the manometer.

EXPLOSION HAZARD!

- NEVER exceed 3.5 bar (50 Psi) when seating beads or inflating tyres.
IMPORTANT! If a higher tyre inflation pressure is required, remove the wheel from the tyre changer and
continue the inflation procedure with the wheel inside a special protection cage (commercially available).
- NEVER exceed the maximum inflation pressure given by the tyre manufacturer.
- ALWAYS keep hands and entire body back from inflating tyre.
- ONLY specially trained personnel are allowed to perform these operations.
- Do not allow other to operate or be near the tyre changer.
1
57
U/1
2
U/2
S 45