Unpacking; Assembly - SICE S 45 Manuel D'instructions

4- The installation site must be equipped with a connection to a compressed
air network with an operating pressure of at least 8 bar.

6.2 UNPACKING

1 - Remove the tyre changer from the packing and check to make sure that
the machine is in a perfect condition. Make sure that there are no visibly
damaged parts.
2 - Remove all the screws that fix the machine to the pallet, using a N° 13
setscrew wrench.
3 - Slide the tyre changer sideways from the pallet with the greatest care.
N.B.: Keep the packing material out of the reach of children as it can
be a source of danger.
Take the packing materials to an appropriate solid waste disposal pick
up point if they are polluting or non-biodegradable.

6.3 ASSEMBLY

FITTING THE POST:
1) Fit the block of the diagonal rod cylinder into the seat on the arm and
secure it by tightening the 2 screws (13, Fig. E).
2) Remove the left-hand side panel by undoing the 4 fixing screws.
3) Remove the panel from the vertical post by simply pulling it outward.
4) Unpack the filter/lubricator (8, Fig. C) which is taped to the rod (12, Fig.
C) of the cylinder, taking care to keep it vertical so that no oil spills out.
5) Place the post (10, Fig. C) on the body, inserting the plastic hose (11,
Fig. C) through the opening provided, then fully tighten the 4 screws (4,
Fig. C) after fitting the washers (5, Fig. C).
6) Check that the rod of the cylinder (12, Fig. C) fits into the bracket (6,
Fig. C).
7) Remove one of the 2 snap rings from the pin (7, Fig. C) then fit the pin
into the bracket and through the hole in the rod of the cylinder from behind.
8) Secure the pin (7, Fig. C) using the snap ring (1, Fig. C) removed earlier.
9) Connect the plastic hose (11, Fig. D) to the union (3, Fig. D), pushing
the hose right down onto the union, then tighten the nut (2, Fig. D) (do not
over-tighten to avoid crushing the hose to the point where it disintegrates).
10) Fix the filter/lubricator (8, Fig. C) by fitting the supporting bracket
between the screws (9, Fig. C) and tightening them.
S 45
6
1
7
12
11
3
13
15
19
36
ENGLISH • Instructions manual
10
11
9
2
14
17
18
8
4
5
C
D
E
16
F