Unpacking; Workplace Requirements; Electric Hook Up - SICE S 560 Manuel D'instruction

WARNING!
The machine must not be operated in explosive environments.
Once the packing material has been removed, check the machine visually for any signs of damage.
Keep the packing materials out of the reach of children as they can be a source of danger.
N.B.: Keep the packing for possible future transport.

6.3 WORKPLACE REQUIREMENTS

Maximum machine space requirements are 2820 X 2300 mm with a minimum distance
from walls as shown in the diagram B/4.
CAUTION! These measurements are also the tyre changers
working range.
Persons other than specially trained and authorized
operators are expressly forbidden to enter this area.
Position the tyre changer lifting it with the specific bracket (1, Fig. A) with the
tool carrier arm (2, Fig. A) lowered all the way, the spindle (3, Fig. A) closed and
the tool carrier slide (13, Fig. A) at its stop close to the arm.
FIXING THE MACHINE
The machine should be fixed to the floor when the wheels
handled weigh more than 1000 kg.
To anchor the machine to the floor use 2 Ø 16 metal expand-
ing bolts.
Drill holes in the floor at the fixing points in the machine's
feet as indicated by the arrows in Figure B/5.
Insert the expansion bolts in the drilled holes and tighten
the screws all the way.
Before making any electric hook up, check to be certain that the mains voltage corresponds to that stamped on the voltage tag (at-
tached to the cord near the tyre changer's plug).
It is absolutely essential that :
- the system is equipped with a good grounding circuit.
- The machine is connected to a power supply line circuit breaker set for 30 mA.
S 560

6.2 UNPACKING

6.4 ELECTRIC HOOK UP

36
ENGLISH • Instructions manual
600 mm
2500 mm
B/4
B/5