Installing The Drager ® Incubator - Stryker Power-PRO IT Manuel D'utilisation

INSTALLING THE DRAGER
®
Prior to installing the Drager
the manual supplied with the incubator.
WARNING
®
• The Drager Incubator adaptor (6516-129-000) is designed to secure only Drager
6510 Power-PRO™ IT cot. Using this adaptor on any cot other than the model 6516 Power-PRO™ IT cot or using
any unapproved incubators in this configuration may result in damage to the cot and/or injury to the patient or user.
• Stryker is not responsible for specifications changes to the Drager
To install the incubator:
1. Pull the red latch handle (A) on the adaptor and move it to the right until the slot in the handle engages with the
shoulder bolt (B) on the adaptor as shown in Figure 38.
2. Place the incubator on the adaptor. Align the holes in the incubator with the four pins (C) on the adaptor (only two
of the four pins are shown).
3. Move the latch handle to the left to release it. The handle retracts and the latches engage to secure the incubator.
Inspect all four locking points to verify that the latches are securely engaged and are not obstructed by anything
(hoses, wires, etc.).
www.stryker.com
Cot Operation
®
INCUBATOR
Incubator on the model 6516 Power-PRO™ IT cot, read and understand this manual and
C
C
C
C
Figure 38: Drager
6516-109-005 REV B
® (or Air-Shields ® Series) incubators.
®
Incubator
® incubators to the
B
B
A
A
Return To Table of Contents
1-53
English