Operation Guide; Operating Guidelines; Proper Lifting Techniques - Stryker Power-PRO IT Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING GUIDELINES

English
• Use the cot only as described in this manual.
• Read all labels and instructions on the cot before using the cot.
• Before first and every use, inspect the SMRT™ Pak housing and terminal area for cracks and/or damage.
• Loading or unloading an occupied cot into a vehicle requires a minimum of two (2) trained operators. One or
two operators can lift from the foot end of the cot. Stryker recommends that both operators are at the foot end
to reduce the load on each operator. If additional assistance is needed, see "Using Additional Assistance" on
page
1-46.
• Do not adjust, roll or load the cot into a vehicle without advising the patient. Stay with the patient and control the
cot at all times.
• The cot can be transported in any position. Stryker recommends that the operators transport the patient in the
lowest comfortable position to maneuver the cot.
• Only use the wheel locks during patient transfer or without a patient on the cot.
• Do not leave wheel locks engaged while transporting the cot. Failure to do so may cause wheel damage.
• Use properly trained helpers, when necessary, to control the cot.
WARNING
• Improper usage of the cot can cause injury to the patient or operator. Operate the cot only as described in this
manual.
• Entanglement in powered cot mechanisms can cause serious injury. Operate the cot only when all persons are clear
of the mechanisms.
• Inspect SMRT™ Paks for damage before every use.
• Practice changing height positions and loading the cot until operation of the product is fully understood. Improper
use can cause injury.
• Do not allow untrained assistants to assist in the operation of the cot. Untrained technicians/assistants can cause
injury to the patient or themselves.
• Ensure proper hand placement on hand grips. Hands should be clear of red safety bar pivots while loading and
unloading the cot or whenever changing height position of the cot with two or more operators.
• Do not ride on the base of the cot. Damage to the product could occur, resulting in injury to the patient or operator.
• Transporting the cot sideways can cause the cot to tip, resulting in possible damage to the product and/or injury to
the patient or operator. Transporting the cot in a lowered position, head or foot end first, minimizes the potential of
a cot tip.
• Grasping the cot improperly can cause injury. Keep hands, fingers and feet away from moving parts. To avoid injury,
use extreme caution when placing your hands and feet near the base tubes while raising and lowering the cot.
• Any emergency vehicle to be used with this cot must have the in-fastener shut-off system installed (if not using
Power-LOAD) (see
CAUTION
Before operating the cot, clear any obstacles that may interfere and cause injury to the operator or patient.

PROPER LIFTING TECHNIQUES

When lifting the cot and patient, there are five basic guidelines to help you avoid injury:
• Keep your hands close to your body.
• Keep your back straight.
• Coordinate your movements with your partner and lift with your legs.
• Avoid twisting.
• Always operate the cot as described in this manual.
Return To Table of Contents
1-30

Operation Guide

page
1-22).
6516-109-005 REV B
www.stryker.com

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

6516

Table des Matières