Cot Operation; Installing And Removing The Incubator Adaptor; Required Tools - Stryker Power-PRO IT Manuel D'utilisation

INSTALLING AND REMOVING THE INCUBATOR ADAPTOR

Notes:
• If the adaptor was ordered with the model 6516 Power-PRO™ IT cot, the incubator adaptor may have been
installed at the factory.
• If the adaptor was purchased as a retrofit kit, follow these instructions for installation.
WARNING
These adaptors are intended for use only on the model 6516 Power-PRO™ IT cot. They are not intended for installation
on any other Stryker cot or on any cot from another manufacturer. Using these adaptors on any cot other than the
model 6516 Power-PRO™ IT cot may result in damage to the cot and /or injury to the patient or user.
1. Remove the existing adaptor (if there is one already present). See Table 1.0 to locate the pages for removal and
installation instructions of each adaptor.
2. Install the new incubator adaptor. See Table 1.0 to locate the pages with removal and installation instructions of
each adaptor.
3. Align the adaptor assembly with the mounting holes in the Power-PRO™ IT cot as shown in the appropriate
illustration.
4. Reference the appropriate illustration to determine the correct location for installation of the provided fasteners.
Apply a few drops of the provided Loctite
5. Install the incubator on the adaptor. See Table 2.0 to locate the pages for installation instructions of each incubator.
Incubator/Module
Airborne™ Side-by-Side
Drager
Airborne™ Stackable
Air Sled (No Adaptor Option)
WARNING
Verify that the adaptor is properly installed on the cot and the incubator is securely fastened to the adaptor prior to use.
An improperly attached adaptor or incubator may cause injury to the patient or user.
www.stryker.com

Cot Operation

® to the threads of the fasteners and tighten them securely.
Page
page 136
page 142
®
page 145
page 147
Table 1.0
Incubator
Airborne™ Side-by-Side
Drager ®
Airborne™ Stackable
Air Sled (No Adaptor Option)
Table 2.0
6516-109-005 REV B

Required Tools

• 5/32" Allen Wrench
• 3/16" Allen Wrench
• 1/2" Socket & Ratchet
• 5/32" Allen Wrench
• 3/16" Allen Wrench
• 1/2" Socket & Ratchet
• 1/2" Socket & Ratchet
Page
page 1-52
page 1-53
page 1-55
page 1-56
Return To Table of Contents
English
1-51