Vehicle Safety Hook Selection - Stryker Power-PRO IT Manuel D'utilisation

Note: The Vehicle Safety Hook Selection and Installation instructions on
cots that you will NOT use with Power-LOAD. For Model 6516 cots with the Power-LOAD option, see the Power-LOAD
Operations/Maintenance Manual for installation instructions. Power-LOAD ships and is installed with its own safety
hook, thus no additional hook is needed.
The vehicle safety hook is a device that ships with the cot. The cot safety bar and vehicle safety hook are designed
to keep the cot from being accidentally removed from the vehicle and to provide increased operator assurance and
confidence when loading and unloading. The safety hook was designed for compatibility and proper operation when
loading and unloading the cot from a vehicle that is compliant with Federal Regulation KKK-A-1822.
Stryker offers three different types of safety hooks that
are ordered and shipped with your cot. These safety
hook types are designed to meet the needs of various
emergency vehicle configurations, specifically the
length and location of the floor structure support that
is located in the rear of the vehicle.
Consider the following information when selecting
which safety hook is appropriate for your vehicle
configuration:
• Determine the location of the floor structure
support where there is adequate room to mount
the safety hook.
• Ensure that the safety hook can be securely
mounted into the back of the vehicle while
providing adequate bumper clearance to allow the
cot to be loaded and unloaded from the vehicle.
• Note the differences in vehicle design. Each safety
hook provides a different mounting location option
to maintain the appropriate distance between the
face of the safety hook and the edge of the door sill.
Due to the differences in vehicle dimensions and the floor structure support locations, each safety hook requires a
different mounting location. See "Vehicle Safety Hook Installation" to determine the correct positioning for safety hook
installation.
Note: When replacing an existing safety hook with a new style, adjust the mounting location to maintain the proper
position of the safety hook face.
www.stryker.com

Vehicle Safety Hook Selection

6516-109-005 REV B
page 1-23 through page 1-26
Long Safety Hook
6060-036-018
Short Safety Hook
6060-036-017
J-Style Safety Hook
6092-036-018
Figure 12: Safety Hook Types
Return To Table of Contents
are intended for
English
1-23