Operation
When the ignition key is turned to OFF the immobilizer
inhibits engine operation. When the ignition key is turned
from OFF to ON (Key-ON) to start the engine:
1) if the CPU recognised the code, the IMMO light (3, fig. 5)
on the instrument panel will flash briefly. This means that
the immobilizer system has recognised the key code and
enabled engine ignition. When you press the
start button (2, fig. 20), the engine starts;
2) If the IMMO light stays on, it means that the code has
not been recognised. When this is the case, turn the
ignition key back to OFF and then to ON again. If the
engine still does not start, try with another black key.
If the other key does not work out either, contact the
DUCATI Service network.
3) Should the IMMO light still be flashing, it means that
an immobilizer system fault was reset (e.g. with the
overriding procedure through throttle grip).
Important
Use only one key during the procedure. Failure to
do so might prevent the system from recognizing the
code of the key in use.
Duplicate keys
If you need any duplicate keys, contact the DUCATI Service
network with all the keys you have left and your CODE CARD.
DUCATI Service will program new keys and re-program
your original keys, up to 8 keys in total.
You may be asked to identify yourself as the legitimate
owner of the motorcycle. Be sure you have any
documents you might need to this end ready.
engine
The codes of any keys not submitted will be wiped off
from the memory to make those keys unserviceable in
case they have been lost.
Notes
If you sell your motorcycle, do not forget to give all
keys and the CODE CARD to the new owner.
E
25