Operation
When the ignition key is turned to OFFthe immobilizer
inhibits engine operation. When the ignition key is turned
from OFF to ON (Key-ON) to start the engine:
1) if the CPU recognised the code, the IMMO light
(3, fig. 5) on the instrument panel will flash briefly.
This means that the immobilizer system has
E
recognised the key code and enabled engine
ignition. When you press the
button (2, fig. 21), the engine starts;
2) If the IMMO light stays on, it means that the code
has not been recognised. When this is the case, turn
the ignition key back to OFF and then to ON again.
If the engine still does not start, try with another
black key. If the other key does not work out either,
contact the DUCATI Service network.
3) Should the IMMO pilot light still be flashing, it means
that an immobilizer system fault was reset (e.g. with
the overriding procedure through throttle grip).
Important
Use only one key during the procedure. Failure to do
so might prevent the system from recognizing the code of
the key in use.
28
Duplicate keys
If you need any duplicate keys, contact the DUCATI
Service network with all the keys you have left and your
CODE CARD.
DUCATI Service will program new keys and re-program
your original keys, up to 8 keys in total.
You may be asked to identify yourself as the legitimate
owner of the motorcycle. Be sure you have any
documents you might need to this end ready.
engine start
The codes of any keys not submitted will be wiped off
from the memory to make those keys unserviceable in
case they have been lost.
keys and the CODE CARD to the new owner.
Notes
If you sell your motorcycle, do not forget to give all