Chain tension inspection (fig. 51)
Move the motorcycle slowly until you find the point
at which the upper section of chain is tautest.
Set the motorcycle on its side stand. Push the chain
upwards with one finger at swingarm mid-length
(see label). The lower length of the chain should have
20-25 mm slack.
If this condition does not obtain, contact a Ducati
Dealership or Authorised Workshop to have the chain
retensioned.
E
Warning
The eccentric hub screws must be correctly locked
down for rider and passenger safety.
Important
Improper chain tension will lead to early wear of
transmission parts.
Chain lubrication
The chain fitted on your motorcycle has O-rings that keep
dirt out of and lubricant inside the sliding parts.
The seals might be irreparably damaged if the chain is
cleaned using any solvent other than those specific for
chains or washed using steam or water jets. After cleaning,
blow the chain dry or dry it using absorbent material and
lubricate with SHELL Advance Chain or Advance Teflon
Chain on each link.
52
Important
Using non-specific lubricants may lead to severe
damage to chain, front and rear sprocket.
20 ÷ 25 mm
fig. 51