Beam Setting - Ducati MONSTER S4R Manuel D'utilisation Et Entretien

Masquer les pouces Voir aussi pour MONSTER S4R:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Number plate light (fig. 58)
To access the number plate light bulb (3), slide out the bulb
holder from inside, then extract and replace the bulb.
E
Beam setting (fig. 59)
When checking the beam setting, put the motorcycle
upright. Tyres should be inflated at the correct pressure
and one person should be sitting astride the motorcycle,
keeping it at right angles to its longitudinal axis facing a wall
or screen at a distance of 10 metres. Draw a horizontal line
dictated by headlamp center and a vertical one in line with
the longitudinal axis of motorcycle.
If possible, perform this check in dim light.
Switch on the low beam.
The height of the light spot (measured at the upper limit
between dark and lighted-up area) should not exceed 9/10
of the height from ground of headlamp center.
56
th
3
fig. 58
9
x
10
10 m
fig. 59
x

Publicité

Table des Matières
loading

Table des Matières