Changing Motorcycle Track Alignment - Ducati MONSTER S4R Manuel D'utilisation Et Entretien

Masquer les pouces Voir aussi pour MONSTER S4R:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Changing motorcycle track alignment

(fig. 28-fig. 29-fig. 30)
Motorcycle track alignment is the results of tests carried
out under different riding conditions by our technical staff.
Modifying factory setting is a very delicate operation,
which may lead to serious damages if carried out by
unskilled people.
Before changing the standard setting, measure the
reference value (H, fig. 28).
E
The rider can modify track alignment according to his/her
needs by changing working position of the shock
absorber,
To modify the ball joint centre distance (1) first slacken off
the locknuts (3).
Notes
Please note that the lower nut (3) has a left-hand
thread.
Adjust the linkage (2) with an open wrench.
When finished, tighten the nuts (3) to 25 Nm.
Warning
Length of linkage (2), included between the two joint
center lines (1), should not exceed 272 mm.
32
1
3
2
2
1
H
fig. 28
3
fig. 29

Publicité

Table des Matières
loading

Table des Matières