Stopping The Alarm / Switching Off The Alarm - Sygonix 2299888 Mode D'emploi

Activation via user fingerprint
Place your finger on the sensor surface (1). If a valid fingerprint
is detected, the code lock will emit a beep and the LED indicator
(2) will turn green (the fingerprint sensor light will turn blue) to
indicate that the changeover contact has been activated. In toggle
mode, a second reading of the fingerprint closes the code lock.
Activating the changeover contact via the opening button
If a door opener button has been connected to the code lock,
the changeover contact can be activated by briefly pressing the
button. The activation duration is the same as the duration which
is used for a valid user transponder or user fingerprint. In toggle
mode, the opening button changes the switch position of the
changeover contact.
b) Stopping the alarm / switching off the
alarm
The code lock monitors the number of opening attempts. After ten
incorrect opening attempts, an alarm is triggered. When the alarm
is triggered, you can stop it in several ways:
- Enter the correct master code +
- Enter the correct master fingerprint using the fingerprint
sensor
- Enter a valid fingerprint
- Present a previously added transponder
via the remote control
51