Sygonix 2299888 Mode D'emploi page 39

• Activate programming mode by reading the master fingerprint;
the LED indicator (2) will flash red.
• The LED indicator will light up orange. The code lock is now
in add mode.
• In order to add a user transponder or fingerprint, read it by
presenting and removing it three times.
• The code lock will beep and the LED indicator (2) will briefly
turn green. The LED indicator (2) will then turn orange again.
If the master fingerprint cannot be found in the code
lock memory, the code lock will emit 3 short beeps and
the LED indicator (2) will flash red before switching
back to orange.
• You can add additional user transponders or fingerprints
using the same procedure.
• Present the master fingerprint to end the programming
process.
Deleting transponders or fingerprints using the master
fingerprint
Proceed as follows:
• The code lock must be in standby mode and the LED
indicator must be red.
• Activate programming mode by presenting the master
fingerprint twice within a period of no more than 5 seconds.
39