Using The Master Fingerprint - Sygonix 2299888 Mode D'emploi

• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator will then flash red.
Example:
• Press the
code lock is now in delete mode.
• Enter
• Press the
will light up green briefly, and then orange again.
• All user data (fingerprints, transponders) will be deleted. The
master code will be reset. However, the master fingerprint will
not be deleted, as this is part of the user information.
• To end the deletion process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
k) Using the master fingerprint
Adding transponders or fingerprints via the master
fingerprint
Proceed as follows:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
38
key. The LED indicator will light up orange. The
.
button to confirm your entry. The LED indicator
key. The LED indicator will switch to constant