Sygonix 2299888 Mode D'emploi page 29

• The LED indicator (2) will then turn orange again.
• The new user fingerprint will be associated with the
automatically assigned user ID.
If the two fingerprints do not match, the code lock will
emit three short beeps and the LED indicator (2) will
flash red before turning orange. If this occurs, repeat
the adding process again.
The same applies if you enter a user ID which is
already assigned to a fingerprint.
A previously added/stored fingerprint cannot be
assigned again to another user ID.
• You can now add another user fingerprint. The next user ID
will be automatically assigned. To do this, start by placing the
next finger you want to add on the sensor and proceed in the
same way as described above.
• To end the adding process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
Second option: Adding a user fingerprint with manual
assignment of a user ID
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
key. The LED indicator (2) will switch to constant
29