Sygonix 2299888 Mode D'emploi page 44

Activating the changeover contact via a user fingerprint or
user transponder (default setting)
Hold a transponder in front of the sensor surface or place
your finger on the fingerprint sensor. If the transponder or the
fingerprint is valid, the changeover contact will be activated.
Activating the changeover contact via a user fingerprint
Hold your finger on the fingerprint sensor. If a valid fingerprint
is detected by the code lock, the changeover contact will be
activated.
The changeover contact cannot be activated with transpon-
ders stored in the code lock.
Activating the changeover contact via a user transponder
Hold a transponder in front of the sensor surface. If a valid
transponder is detected by the code lock, the changeover contact
will be activated.
The changeover contact cannot be activated with fingerprints
stored in the code lock.
The lock is opened according to the selected setting. For more
information, refer to section "a) Opening and closing the door"
in "Operation".
To configure the access mode, proceed as follows:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
44