Sygonix 2299888 Mode D'emploi page 14

• Remove the top part of the housing with the fingerprint sensor
from the mounting plate. To do this, unscrew the locking
screw (4) on the bottom with the hex key provided, and then
remove the upper part of the housing.
• Use the mounting bracket as a template. Place it on the
mounting surface and mark the two mounting holes.
• Drill the holes and, depending on the surface, insert the
dowels (included). On wood or metal surfaces, the dowels
are not required.
Use the fixing screws, and if necessary, the dowels
provided to secure the housing (when securing to
walls). Ensure that no cables or wires are damaged
when drilling holes or tightening screws.
• Screw the mounting plate to the wall securely. The connection
cable should be fed through the cable feed in the middle of
the rear panel.
14