Setup; Remote Control - Sygonix 2299888 Mode D'emploi

The connection steps for this code lock depend on the
type of door opener you wish to use. Refer to section
"a) Connection" for information on which contacts the
door opener should be connected to.
Check which type of door opener you wish to use. A fail-
secure door opener requires relatively high currents for
short periods in order to open the door and is therefore
not designed to be subjected to continuous loads.

9. Setup

a) Remote control
• If a small transparent plastic strip protrudes from the bottom of
the IR remote control, the battery is already inserted. Pull the
plastic strip out of the IR remote control. The remote control will
then be ready for use.
• Change the battery when the code lock stops responding
to the remote control under normal conditions (and you are
sure that the infrared sensor is clean and that there are no
obstructions).
• To change the battery, pull out the battery holder (7) on the
bottom of the IR remote control. Replace the depleted battery
(1x CR2025) with a new one. Push the correctly oriented
battery holder back into the IR remote control (the plus pole/+
of the battery should point towards the bottom of the IR remote
control).
20