Adding User Transponders With Automatic Assignment Of The User Id - Sygonix 2299888 Mode D'emploi

A fingerprint that has already been added/saved cannot
be used again for another user ID.
• You can now add another user fingerprint. Start by entering
the user ID.
• To end the adding process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
f) Adding user transponders with automatic
assignment of the user ID
General information
• A specific user ID (a number from
can be assigned to each user transponder. The user ID
has a special function. See section 11 "Programming", "a)
General information" for details.
Transponders can also be added without a user ID. This speeds
up the adding of transponders.
If a user ID is not specified when a user transponder is added,
the code lock will automatically assign the next available user ID.
However, it will not then be possible to determine which ID was
assigned.
If you do not assign a specific user ID to a user and
record it in a list, this can lead to problems later.
If an employee leaves the company or loses a user
transponder, you will not know which user ID to delete,
and the transponder will not be available for deletion!
key. The LED indicator (2) will switch to constant
to
31
)