Programming; General Information - Sygonix 2299888 Mode D'emploi

• Point the remote control in the direction of the code lock to
make settings and program users.
• Press the designated button as described.
• The code lock will beep to confirm each entry.

11. Programming

a) General information
Program the code lock at the installation location/
before mounting to reduce the installation time.
Do not disconnect the code lock from the power supply during
programming. This may result in memory errors and corrupt the
existing data/settings. Note the following important information:
• The master code is required to enter programming mode. By
default, the master code is "123456".
• Each transponder user can be assigned a specific user ID
(this is a number from 100 to 989, without "0" at the beginning).
The adding and saving of fingerprints or transponders is also
possible without entering a user ID (the code lock assigns
it automatically). In this case, however, a specific user can
only be deleted if their user fingerprint or transponder is still
available.
• We therefore recommend that you also assign a user ID for
each fingerprint and transponder that you want to add to the
code lock.
22