Sygonix 2299888 Mode D'emploi page 32

Instead of simply deleting the corresponding user ID
with the saved transponder, all data stored in the code
lock would have to be deleted for security reasons in
order to prevent unauthorised access.
We therefore recommend that you assign a user ID for
each authorised person and enter all data (employee
name, user ID, access by transponder or fingerprint,
etc.) in a list.
First option: Adding a user transponder with automatic
assignment of the user ID
The code lock automatically uses the next available user ID, but it
is not possible to determine which one:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
code lock is now in add mode.
• To add a user transponder, hold it in front of the code lock
(near to the fingerprint sensor).
• When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn orange again.
• The new user transponder is now saved.
32
key. The LED indicator (2) will turn orange. The