Deleting All User Data - Sygonix 2299888 Mode D'emploi

LED indicator (2) will then flash red.
Example:
• Press the
will turn orange. The code lock is now in delete mode.
• Enter the user ID that you want to delete via the remote
control and complete your entry with the
Example:
• When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn orange again. The user ID has
now been deleted.
If the user ID cannot be found in the code lock memory,
the code lock will emit 3 short beeps and the LED
indicator (2) will flash red before switching back to
orange.
• You can now delete other user IDs.
• To abort the deletion process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
j) Deleting all user data
This function allows all user data (all fingerprints and
transponders) to be deleted from the code lock memory.
Proceed as follows:
• The code lock must be in standby mode and the LED
indicator must be red.
key on the remote control. The LED indicator (2)
key. The LED indicator (2) will switch to constant
key.
37