Selecting The Access Mode - Sygonix 2299888 Mode D'emploi

paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
will turn orange. The code lock is now in delete mode.
• To delete a guest transponder, hold it in front of the code lock
(near to the fingerprint sensor).
• When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn orange again.
• The transponder is now deleted. If the transponder cannot be
found in the code lock memory, the code lock will emit 3 short
beeps and the LED indicator (2) will flash red before switching
back to orange.
• You can now delete another guest transponder. Simply hold it
in front of the code lock as described above.
• To end the deletion process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
m) Selecting the access mode (transponder or
fingerprint)
There are a number of ways to activate the changeover contact
(relay) of the code lock. You can choose from three access
modes. Opening methods:
key on the remote control. The LED indicator (2)
key. The LED indicator (2) will switch to constant
43