•
To add a user transponder, hold it in front of the code lock
(near to the fingerprint sensor).
•
When the transponder has been read, the code lock will beep
and the LED indicator (2) will briefly turn green. The LED
indicator (2) will then turn orange again.
•
The new user transponder will be associated with the entered
user ID.
A transponder that has already been added/saved
cannot be added again. In this case, the code lock
emits 3 short beeps and the LED indicator (2) flashes
red before turning orange again.
The same applies if you enter a user ID which is
already assigned to a transponder.
•
You can now add another user transponder. Start by entering
the user ID and follow the steps above.
•
To end the adding process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
g) Deleting a user fingerprint
•
The code lock must be in standby mode and the LED
indicator (2) must be red.
•
Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
34
key. The LED indicator (2) will switch to constant