Deleting A User Transponder - Sygonix 2299888 Mode D'emploi

• Press the
will turn orange. The code lock is now in delete mode.
• Hold the fingerprint that you want to delete from the code lock
system on the fingerprint sensor.
• When the fingerprint has been detected, the code lock will
emit a beep and the LED indicator (2) will briefly turn green.
The LED indicator will then turn orange again.
• The user fingerprint has now been deleted.
If the fingerprint was not recognized or cannot be found
in the code lock memory, the code lock will emit 3 short
beeps and the LED indicator (2) will flash red before
switching back to orange.
• You can now delete another user fingerprint. Simply hold the
finger on the fingerprint sensor as above.
• To end the deletion process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
h) Deleting a user transponder
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
key on the remote control. The LED indicator (2)
key. The LED indicator (2) will switch to constant
35