Sygonix 2299888 Mode D'emploi page 30

• Press the
code lock is now in add fingerprint mode.
• Enter a user ID (a number from
• Press the
will briefly turn green, and then orange again.
• Hold a finger on the fingerprint sensor (1). The code lock will
beep when the fingerprint has been read.
• Take your finger off the fingerprint sensor.
• Place the same finger on the fingerprint sensor again. When
the fingerprint has been detected and it matches with the first
fingerprint, the code lock will beep and the LED indicator (2)
will briefly turn green.
• Take your finger off the fingerprint sensor.
• Place the same finger on the fingerprint sensor for a third
time. When the fingerprint has been detected and it matches
with the first fingerprint, the code lock will beep and the LED
indicator (2) will briefly turn green.
• The LED indicator (2) will then turn orange again.
• The new user fingerprint will be associated with the entered
user ID.
If the fingerprints do not match, the code lock will emit
three short beeps and the LED indicator (2) will flash
red before turning orange. If this occurs, repeat the
adding process again.
The same applies if you enter a user ID which is
already assigned to a fingerprint.
30
key. The LED indicator (2) will turn orange. The
key to confirm the user ID. The LED indicator (2)
to ).