Sygonix 2299888 Mode D'emploi page 26

• Press the following keys:
fingerprint sensor (1). When the fingerprint has been read,
the code lock will emit a short beep and the LED indicator (2)
will briefly turn green.
• Take your finger off the fingerprint sensor.
• Place the same finger on the fingerprint sensor again. When
the fingerprint has been detected and it matches with the first
fingerprint, the code lock will emit another short beep and the
LED indicator (2) will briefly turn green.
• Take your finger off the fingerprint sensor.
• Place the same finger on the fingerprint sensor for a third
time. When the fingerprint has been detected and it matches
with the first two fingerprints, the code lock will emit another
short beep and the LED indicator (2) will briefly turn green.
• The LED indicator (2) will then turn orange again.
• The master fingerprint is stored in the previously entered
reserved ID-99.
If the two fingerprints do not match, the code lock will
emit three short beeps and the LED indicator (2) will
flash red before turning orange. If this occurs, repeat
the adding process again.
The same applies if you enter a user ID which is
already assigned to a fingerprint.
26
. Hold a finger on the