•
To add the guest transponder, hold it in front of the code lock
(close to the fingerprint sensor) and complete the process
with the
Example
•
When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn orange again.
•
The guest transponder has now been saved to the previously
entered guest ID.
A transponder that has already been added/saved
cannot be added again. In this case, the code lock
emits 3 short beeps and the LED indicator (2) flashes
red before turning orange again.
The same applies if you enter a guest/user ID which is
already assigned to a transponder.
•
You can now add other guest transponders. Start by entering
the guest ID and follow the steps above.
•
To end the adding process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
Deleting guest transponders with a guest ID
•
The code lock must be in standby mode and the LED
indicator (2) must be red.
•
Enable programming mode (see section 11 "Programming",
key on the remote control:
key. The LED indicator (2) will switch to constant
Read transponder
41