Sygonix 2299888 Mode D'emploi page 49

The alarm can be terminated prematurely with the valid master
code, a valid user PIN code or by presenting a valid transponder.
The alarm is disabled by default.
To configure the security function, proceed as follows:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
• Enter the desired function:
= Alarm is switched off.
= Code lock is locked for 10 minutes
= Alarm sounds for 1 to 3 seconds. (The default setting
is one minute.)
• Press the
will briefly turn green and then flash red (programming mode).
• To exit programming mode, press the
indicator (2) will switch to constant red to indicate that the
code lock is in standby mode.
key. The LED indicator (2) will turn orange.
key to confirm your entry. The LED indicator (2)
key. The LED
49