Entering/Exiting Programming Mode - Sygonix 2299888 Mode D'emploi

• These should be recorded in a list together with other data
(employee name, access via fingerprint or transponder).
• Of the 1000 available user IDs, some are reserved for special
functions: e.g.
deleting user fingerprints or user transponders.
• One fingerprint and one transponder can be assigned to each
user ID.
• Any standard EM transponder which works with a transponder
frequency of 125 kHz can be used as a transponder.
b) Entering/exiting programming mode
To enter programming mode, you need to enter the master code
using the IR remote control. By default (default factory settings or
after a reset), the master code is "123456".
In the following programming examples, "123456" is
used as a master code (default setting).
Change the master code as soon as possible – no later
than when you have finished the programming steps.
Entering programming mode:
• The LED indicator (2) on the top of the code lock must be red.
The code lock is now in standby mode.
• Press the
signal from the remote control, the LED indicator on the code
lock will flash red (the code lock will automatically return to
standby mode after 5 seconds without any further input (LED
indicator (2) turns red).
The master fingerprint for adding and
key. Once the code lock has detected the IR
23