Deleting Fingerprints Or Transponders Using User Ids - Sygonix 2299888 Mode D'emploi

Example:
• Press the
will turn orange. The code lock is now in delete mode.
• To delete a user transponder, hold it in front of the code lock
(near to the fingerprint sensor).
• When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn orange again.
• The user transponder is now deleted. If the transponder
cannot be found in the code lock memory, the code lock will
emit 3 short beeps and the LED indicator (2) will flash red
before switching back to orange.
• You can now delete another user transponder. Simply hold it
in front of the code lock as described above.
• To abort the deletion process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
i) Deleting fingerprints or transponders using
user IDs
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
36
key on the remote control. The LED indicator (2)
key. The LED indicator (2) will switch to constant