o) Setting the alarm duration
The alarm duration for the security function can be set (from 1 to
3 minutes, default setting = 1 minute). To configure the alarm and
alarm duration, proceed as follows:
•
The code lock must be in standby mode and the LED
indicator (2) must be red.
•
Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
•
Press the
•
Enter the desired function:
= Alarm is switched off.
-
= Alarm sounds for 1 to 3 seconds. (The default
setting is one minute.)
•
Press the
(2) will briefly turn green and then flash red (programming
mode).
•
To exit programming mode, press the
indicator (2) will switch to constant red to indicate that the
code lock is in standby mode.
key. The LED indicator (2) will turn orange.
button to confirm your entry. The LED indicator
key. The LED
47