Adding Guest User Codes (Transponders Only) - Sygonix 2299888 Mode D'emploi

• The LED indicator will light up orange. The code lock is now
in delete mode.
• To delete a user transponder or fingerprint, present it once.
• You can now delete additional user transponders or
fingerprints.
• Present the master fingerprint to end the programming
process.
l) Adding guest user codes (transponders
only)
Adding a guest transponder by entering the user ID:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
code lock is now in add mode.
• Enter the number of uses for the guest transponder and
complete your entry with the
The number of uses can be set from 1 to 10 (0=10
uses).
• Enter a user ID (a number from
40
key. The LED indicator (2) will turn orange. The
remote control button.
to ).