Sygonix 2299888 Mode D'emploi page 33

A transponder that has already been added/saved
cannot be added again. In this case, the code lock
emits 3 short beeps and the LED indicator (2) flashes
red before turning orange again.
The same applies if you enter a user ID which is
already assigned to a transponder.
• You can now add another user transponder. Simply hold it in
front of the code lock as described above.
• To end the adding process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
Second option: Adding a user transponder with manual
assignment of the user ID
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
code lock is now in add mode.
• Enter a user ID (a number from
See section 11 "Programming", "a) General information" for
details.
• Press the
will briefly turn green, and then orange again.
key. The LED indicator (2) will switch to constant
key. The LED indicator (2) will turn orange. The
key to confirm the user ID. The LED indicator (2)
to
33
).