Sygonix 2299888 Mode D'emploi page 42

paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
will turn orange. The code lock is now in delete mode.
• To delete a guest transponder, enter the guest ID that you
want to delete via the remote control and complete your entry
with the
Example:
• When the guest ID has been deleted, the code lock will beep
and the LED indicator (2) will briefly turn green. The LED
indicator (2) will then turn orange again.
If the guest ID cannot be found in the code lock
memory, the code lock will emit 3 short beeps and the
LED indicator (2) will flash red before switching back to
orange.
• You can now delete other guest IDs/transponders.
• To abort the deletion process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
Deleting a guest transponder with a transponder
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
42
key on the remote control. The LED indicator (2)
key.
key. The LED indicator (2) will switch to constant