Inserting Battery Into The Ir Remote Control, Changing The Battery - Sygonix SY-4548736 Notice D'emploi

c) Inserting battery into the IR remote control, changing the battery
• Peel a thin transparent protective film off the IR remote control, if any.
The battery (1x CR2025) may be pre-inserted in the battery compartment. In this case, you may have
to pull a small transparent protective film out of the battery compartment. It protects the battery against
premature discharge.
• To insert/change a battery, unlock a small locking clip on the battery compartment with a flat screwdriver and then
remove the battery holder.
• Place the battery in the battery holder, observing the correct polarity (plus/+ and minus/-). The plus pole of the
battery and the battery holder is marked with the symbol "+"; both markings must face the bottom of the IR remote
control.
• Put the battery holder back into the IR remote control, observing the correct orientation (plus pole should face the
bottom of the IR remote control), do not use force!
• Dispose of the old, empty battery in an environmentally-friendly manner (see "Disposal").
Replace the battery if the range of the IR remote control drops, or if the monitor/DVR does not respond to
the IR remote control.
53