Reflex Servimat M Mode D'emploi Original page 51

CAUTION
Risk of injury due to pressurised liquid
If installation or maintenance work is not carried out correctly, there is a risk of
burns and other injuries at the connection points, if pressurised hot water or
steam suddenly escapes.
• Ensure proper disassembly.
• Wear suitable personal protective equipment (safety gloves and safety
goggles, for example).
• Ensure that the system is de-pressurised before performing the
disassembly.
Prior to the disassembly, lock out the "DC" degassing lines and the "WC" make-up
line from the system to the Servimat and de-pressurise the Servimat. Then
disconnect the Servimat from all voltages.
Proceed as follows:
1. Switch the system to stop mode and secure it to prevent it being switched
back on.
2. Lock out the "DC" degassing lines and the "WC" make-up line.
3. Switch the system to a voltage-free state. Unplug the Servimat's mains plug
from the power supply.
4. Disconnect all cables from the terminals of the Servimat controller.
DANGER – Risk of serious injury or death due to electric shock. Some
parts of the Servimat's circuit board may still be live with 230 V even after the
device has been physically isolated from the power supply by pulling out of
the mains plug. Before you remove the covers, completely isolate the
Servimat controller from the power supply. Verify that the main circuit board
is voltage-free.
5. Open the "FD" drain cock at the "VT" spray tube of the Servimat until the
spray tube no longer contains any water.
6. If necessary, physically remove the Servimat from the system.
The dismantling process is completed.
 Note!
When using environmentally harmful media, an adequate liquid capture
facility must be provided when draining. Moreover, the operator is obliged
to ensure correct disposal of any such media.
12 Annex
12.1 Reflex Customer Service
Central customer service
Central telephone number: +49 (0)2382 7069 - 0
Customer Service extension: +49 (0)2382 7069 - 9505
E-mail: aftersales@reflex.de
Technical Hotline
For questions about our products
Telephone number: +49 (0)2382 7069-9546
Monday to Friday 8:00 to 16:30
12.2 Conformity and standards
Device conformity declarations are available on the Reflex homepage.
www.reflex-winkelmann.com/konformitaetserklaerungen
Alternatively, scan the QR code:
12.3 Guarantee
The respective statutory guarantee regulations apply.
inhalt_en
Servimat M/L — 25.07.2024
Annex
English — 51