immer-mobil TCN 8200 Mode D'emploi page 93

Install the tyre changer in the chosen work
position, complying with the minimum
clearances shown in fig.7.
The support surface must have a load-
bearing capacity of at least 1000 kg/m
Ambient working conditions
- Relative humidity 30% ÷ 95% without
condensation.
- Temperature 0°C ÷ 50°C.
Whenever the machine is disconnected from the pneumatic line for long periods,
before restoring the pneumatic supply, check the configuration of the pedals as
shown below.
Before proceeding with the electrical and
pneumatic connection and whenever the
electrical and pneumatic power supply is
restored, make sure that the machine is in the
configuration described below:
- pedal A COMPLETELY LOW
(turntable E closed).
- pedal B COMPLETELY LOW
(pole C not tilted).
Operator manual
.
2
500
CAUTION
DANGER
B
A
750
7
C
UK
93